Gas Fire Tubes & Restrictor Kits GAS SAFE REGISTER TM

GAS FIRE TUBES

Copper tubes with various decorative finishes incorporating copper tube to BS 2871 : Part 1 : Table X (EN 1057 half hard). The polished brass finish is achieved by brass plating the copper tube and polishing the plated surface.The brass plated and lacquered finish is obtained by brass plating the copper tube and then lacquering it.
For Natural Gas and LPG.

Chrome Plated

Part No.Description Unit PriceQty

Polished Brass

(see note above)
Part No.Description Unit PriceQty

Coin Bronze

Part No.Description Unit PriceQty

Brass Plated and Lacquered

(see note above)
Part No.Description Unit PriceQty


RESTRICTOR KITS

Kits with Fibre/PTFE Washers

Restrictor kits with 1/4" BSP taper female inlet and 8 mm compression outlet. Will produce either a 2" or 4" high assembly as shown below. See fire tubes for 8 mm fire tubes for use with these kits. P/Ns 4826, 4670 include restrictors 1059. P/Ns 0975, 0973, 8999 include restrictors P/Ns 0251, 0250, or 8997 and are suitable for Natural Gas and LPG as these restrictors are fitted with bonded seals (Click here for top screw washers).

For Natural Gas only.
Part No.Description Unit PriceQty

Part No.Description Unit PriceQty

Kits with Bonded Seals

For Natural Gas and LPG
Part No.Description Unit PriceQty

For Natural Gas and LPG
Part No.Description Unit PriceQty

For Natural Gas and LPG
Part No.Description Unit PriceQty


BRASS ELBOWS

Valor/Cannon Brass Elbows

Fitted to radiant gas fires (the inlet of gas fires).
Part No.Description Unit PriceQty


BACKNEE ELBOWS

1/4" BSP M x 15 mm Capillary Female

Brass elbows which may be used to pass the gas supply to the bottom of the floor plate. For example the long arm may be used through floorboards. P/N 0287 has taper thread to BS 21 and P/N 1410 has a long screw parallel thread to BS 21.
For Natural Gas and LPG.
Part No.Description Unit PriceQty