Oil - Pipe & Fittings GAS SAFE REGISTER TM

QUAL-OIL UNDERGROUND OIL PIPE

Green flexible PE-X plastic pipe for carrying oil underground from an external tank to the point of entry of a building. Impervious to concrete and available in 50 and 100 m lengths to eliminate or reduce buried joints. If joints are needed use BS EN 1254-1:1998 or BS 864-2:1983 compression fittings, with the metal inserts listed below. Resistant to freeze bursting, the pipe has been tested and rated down to -30 °C. Maximum recommended service pressures are 10 bar at 20 °C and 5 bar at 50 °C. The pipe is UV stabilized and may be stored outdoors. Approved by OFTEC. Manufactured in the British Isles by a BS EN ISO 9001:2000 registered company>

Please note that the pipe must not be used within a building, on the boiler side of the fire valve, or within 0.5 m of the oil burner/boiler. It must not be exposed to a radiant heat above 50 °C, and if used above ground must be in a fire proof duct or sleeve. When laying underground the Buried Work Installation Code of Practice for Oil Firing (BS 5410-1:1997 Section 8.2.4) must be followed.

If plastic coated copper tube is preferred, please refer to P/Ns 18097, 8880, and 8881 by clicking on the following link: Copper Tube & Coil. If brown pipe is required to agree with the colour code for oil, brown tape (see below) may be wrapped round the green pipe at intervals. Pipe sizes below refer to the outside diameter.

Part No.Description Unit PriceQty

Metal Inserts for Qual-Oil Pipe Above Only

Part No.Description Unit PriceQty



UNDERGROUND MARKER TAPE

Polyethylene tape for laying underground to give warning of the presence of oil pipes. 365 m long, 150 mm wide. Black text on brown.
Part No.Description Unit PriceQty



OIL PIPE IDENTIFICATION TAPE

Letters 13 mm (1/2") high. Adhesive tape showing OIL. Colour: White on brown.
Part No.Description Unit PriceQty



ROCOL OILSEAL

Hard but flexible setting pipe sealant for metallic threaded and flanged joints, up to 2000 p.s.i. (138 bar). For stainless steel flanges, check sealing performance before using. Primarily for mineral oils, petrol, diesel, fuel oils, white spirit and paraffin. Temperature range : -50°C to 200°C. Keep container tightly closed and store in a cool, well ventilated area.
(Must not be applied in sub-zero temperatures)
Part No.Description Unit PriceQty



OIL LINES

Flexible Oil Lines

Suitable for commercial and domestic heating oils. Manufactured in the UK by a BS EN ISO 9001:2000 registered company.

SPECIFICATION :
Nitrile rubber tube  
Tube bore size : 6 mm
Galvanised overbraid  
Tube working pressure : 15 bar
Temperature range : -20°C to + 80°C

1/4 " BSP Female Swivel x 1/4 " BSP Female Swivel

Part No.Description Unit PriceQty

1⁄4" BSP Male x 1⁄4" BSP Female Swivel

Part No.Description Unit PriceQty

1/4 " BSP Female Swivel x 1/4 " BSP Female Swivel Elbow

Part No.Description Unit PriceQty

3⁄8" BSP Female Swivel x 1⁄4" BSP Male Swivel Elbow

Part No.Description Unit PriceQty



LONG LIFE OIL LINES


Flexible oil lines suitable for kerosene and diesel oil. The rubber gives a high level of flexibility with a minimum bend radius of 64 mm.

SPECIFICATION:
Tube: R6 rubber compound
Tube bore: 6mm
Maximum tube working pressure: 27 bar
Temperature range: -5°C to +80°C

¼" BSP Female Swivel x ¼" BSP Female Swivel

Part No.Description Unit PriceQty

¼" BSP T Male x ¼" BSP Male Swivel Elbow

Part No.Description Unit PriceQty



ADAPTORS FOR OIL LINES

Plated, BSP taper male thread x BSP parallel male (hose end) thread. Will connect oil lines to oil pumps, etc.
Part No.Description Unit PriceQty



OIL LINE FITTINGS

SAE standard fittings as listed in the OFTEC oil firing equipment directive. Fittings range from 6 to 15 mm. Manufactured under systems accredited to BS EN ISO 9001:2000.

Flare Nuts

Part No.Description Unit PriceQty

Male Flare Unions

Part No.Description Unit PriceQty

Male Flare to BSP T Male Adaptors

Part No.Description Unit PriceQty

Male Flare to BSP T Female Adaptors

Part No.Description Unit PriceQty

Male Flare to BSP T Male Elbow Adaptors

Part No.Description Unit PriceQty

Male Flare Elbows

Part No.Description Unit PriceQty

Male Flare Tees

Part No.Description Unit PriceQty

Male Flare Double End Reducers

Part No.Description Unit PriceQty

45° Flaring Tool

Part No.Description Unit PriceQty

FOR FLUE SYSTEMS FOR OIL PLEASE CLICK HERE